Activity LEDs on the Management and AUX Ports

The KVM/netPlus unit comes with paired LEDs positioned on each side of the following ports:

•

User 2

•

AUX 1

•

AUX 2

•

Ethernet

•

Console

The following figure shows the position of the LEDs as they appear on the back of the KVM/netPlus. The LEDs are designed to monitor the interface connections as described in Management Port LED Status Definitions.

LEDs on the KVM/netPlus Management Ports

The LED numbers in the table below correspond to the numbers in the previous diagram.

Management Port LED Status Definitions 

LED No.	Label	Function	Color/Status
1,7	LK	Monitor RS-232 async port status	• Orange – Lights when DTR (data terminal ready) signal is on. • Off – Indicates the port is not open.
2,8	ACT	Monitor RS-232 async activity	• Green – Blinks when data is either being received (RX) or transmitted (TX). • Off – Indicates no data activity.
3	CPU	Monitor CPU	• Green and Orange – Blinks alternating between green and orange when software is operating normally. • Solid Green or Orange - Does not blink during bootup or software crash.
4	GP/HD	Monitor compact flash (HD) or other (GP)	• Orange – Blinks when data activity occurs in compact flash.
5	VID EN	Monitor KVM CAT5 video interface	• Green – Lights when video signal is present.
6	SYN	Monitor KVM CAT5 video interface	• Orange – Lights when the user is connected to a port.
9	ACT	Monitor Ethernet line activity	• Green – Lights solid when data activity occurs. • Off – Indicates no activity.
10	10/100	Monitor Ethernet speed and link.	• Green – Lights when a 100Mbit/sec network is detected. • Orange – Lights when a 10Mbit/sec network is detected. • Off – Indicates no link.